14×4×
Fit corner connectors into two of the posts
Storage unit on castors, 41 × 101 cm
1 h 5 min · one person · 40 steps · 17 panels · 79 fittings
Fit corner connectors into two of the posts
Fit corner connectors into the other two posts
Click the first post into the top
Slide a mesh panel into the post
Swing it in line with the top
Slide the next post onto the panel's free edge
Click that post into the top
Slide the back mesh panel into the first post
Slide the third post onto the back panel
Click it into the top
Slide the last mesh panel in
Slide the last post onto it
Click the last post into the top
Screw the mesh panels to the top
Screw the drawer runners onto the bottom board
Bolt the bottom board onto the posts
Screw in the two castors with brakes
Screw in the two other castors
Tighten the four corner bolts
Click the cable ring into its hole
Stand it up and screw the mesh to the bottom
Put in the lower shelf
Press it down onto the posts
Turn the shelf supports round
Lay the upper shelf on them
Fit the drawer sides to the front
Turn the four cam locks
Slide the bottom into the grooves
Push the back in
Turn the drawer over and screw on the guide rail
Click the small castor into its leg
Screw the leg under the drawer
Screw on the first runner catch
Screw on the other runner catch
Turn it over and screw on the handle bar
Fold the tray
Clip the tray's ends
Set the tray in the drawer
Slide the drawer in
Hang the hook on the side