HYLTARP

Screw four rods into each backrest

Lower the seat frames onto the rods

Screw a wing nut onto each rod

Screw three rods into the armrest

Push the armrest onto the end of the frame

Put a washer and nut on each rod

Screw the long pin into the open end

Screw three rods into the armrest

Push the armrest onto the end of the frame

Put a washer and nut on each rod

Screw the long pin into the open end

Screw the four legs into the armrests

Stick a felt pad under each leg

Screw two rods into each corner backrest half

Lower the corner seat frame onto the back half

Push the side half onto the seat frame

Screw the four short legs into the corner

Stand the corner up and screw on the four U brackets

Lift a section onto the corner together

Hang the other section on the corner

Pull the cover over the sections and the corner

Fasten the cover under the armrests

Tuck the cover in along the seat

Pull the covers onto the cushions

Lay in the seat cushions

Stand the back cushions on the seat

Add the scatter cushions