17×
Screw the cam bolts into both sides
Corner base cab w drawer and p-out, 128 × 68 cm
1 h 45 min · two people · 50 steps · 28 panels · 198 fittings
Screw the cam bolts into both sides
Tap the dowels into the ends of the bottom
Push the right side onto the bottom
Lock the cams
Screw the support block onto the fixed front panel
Screw the front panel onto the bottom
Push the left side on and lock the cams
Nail two plastic brackets where the front panel meets the left side
Tap a dowel into the end of the front strip
Turn it round and slide the front strip in
Screw the strip down onto the front panel
Stand it up and slide the card from the box inside
Screw the back rail across the top
Screw a suspension fitting onto each side
Lay it on its front and nail the backs on at three corners
Nail on the two plastic brackets at the top
Slide the joining strip in where the backs meet
Nail the rest of the backs
Stand it up and screw the post onto the front panel
Hook the hanging bracket onto the back rail
Tap a dowel into the top of the middle panel
Lift the middle panel into place
Bolt the panel to the bracket
Screw the panel to the front
Screw the front rail across the top of the door opening
Press the two plugs into the bottom
Screw the three support plates onto the left side
Lay it on its back and click on the legs
Stand it up together
Screw the suspension rail to the wall and hang the cabinet on it
Set it level and lock the fittings
Click on the cover caps
Screw it to the cabinet beside it
Click the back onto the drawer sides
Slide the bottom in and screw it to the back
Screw the front fittings on and click the front onto the drawer
Click the gallery rails on
Screw the runners into the cabinet
Put the drawer on the runners
Stick on the bumpers
Screw the two mounting tracks to the side
Hook the four swing arms into the tracks
Push the rail posts into both baskets
Join each rim with its two clips
Screw the posts and the brackets to the trays
Set the baskets on the swing arms
Press the corner hinges into the door
Fit the hinge plates on the back of the front panel
Click the door onto the plates
Line up the door and stick on the bumpers