14×8×
Screw a small bracket onto each side
Wash-stand/wash-basin, 102 × 49 × 71 cm
1 h 25 min · two people · 33 steps · 40 panels · 145 fittings
Screw a small bracket onto each side
Screw the hanging brackets onto the sides
Click the back rails into one side of each frame
Hook in the lower back board
Click in the bottom front rail
Press the other side on
Push in the connectors at the top
Push in the connectors at the bottom
Rest the middle shelf on its supports
Screw the lower runners onto the sides
Screw on the upper runners with the spacer plates
Check it's square
Mark where the rails go
Screw the suspension rails to the wall
Hang the frames on the rails
Screw the frames together
Lock the hanging brackets to the rail
Screw the bottom brackets to the wall
Lay a drawer front face down and stick on the bumpers (do this 4 times)
Press the wire clips into the front (do this 4 times)
Slide the sides onto the front (do this 4 times)
Slide the bottom down the grooves (do this 4 times)
Put the back on (do this 4 times)
Lock the back with the dowels and clips (do this 4 times)
Put in the divider (do this 4 times)
Pull the runners out
Set the drawers on the runners and push them in
Line up the fronts
Screw the battens to the wall
Lay the countertop on
Cut the hole for the basin
Set the basin into the hole
Fit the waste and the water trap