12×4×
Screw a small bracket onto each side
Wash-stnd w drawers/wash-basin, 102 × 49 × 69 cm
1 h 25 min · two people · 30 steps · 24 panels · 85 fittings
Screw a small bracket onto each side
Screw the hanging brackets onto the sides
Click the back rail into one side
Hook in the lower back board
Click in the bottom front rail
Press the other side on
Push in the connectors at the top
Push in the connectors at the bottom
Rest the middle shelf on its supports
Screw the lower runners onto the sides
Screw on the upper runners with the spacer plates
Check it's square
Mark where the rail goes
Screw the suspension rail to the wall
Hang the frame on the rail
Lock the hanging brackets to the rail
Screw the bottom brackets to the wall
Lay a drawer front face down and stick on the bumpers (do this 2 times)
Press the wire clips into the front (do this 2 times)
Slide the sides onto the front (do this 2 times)
Slide the bottom down the grooves (do this 2 times)
Put the back on (do this 2 times)
Lock the back with the dowels and clips (do this 2 times)
Screw the support under the bottom (do this 2 times)
Put in the dividers (do this 2 times)
Pull the runners out
Set the drawers on the runners and push them in
Line up the fronts
Lower the wash-basin on
Fit the waste and the water trap