TROTTEN

Fit the left and right brackets on the leg bases

Screw two bolts down through each bracket

Set the lifting columns in and bolt the inner side

Bolt the outer side the same way

Tighten the first four bolts

Slide the two beam halves onto the columns

Tighten the twelve bolts along the beam

Push the first drive shaft in

Fit the motor and push in the second shaft

Click the shaft couplings shut

Bolt the motor to the beam

Add the second motor bolt

Tighten the two screws on the couplings

Screw the top arms onto the beam ends

Screw the control box under the right arm

Plug in the cables and the power

Reset the legs

Unplug it again

Press four rubber pads onto the beam

Lay the top on together

Screw the top on from below

Hook the cable tray on and screw one edge

Swing the tray up and screw the other edge

Screw in the four long bolts

Press the two cable clips in under the top

Fill the unused holes on the left

Fill the unused holes on the right

Plug it in and try it